Some thoughts on HP MSM765zl Wireless Controller

MSM765zl controller has its ports facing the internal Switch Fabric of 5400zl and 8200zl Chassis Switchs.

MSM765zl Ports

Here are my bullets on the consequences of this fact to consider:

  • Has two ports  – LAN and Internet Port – each 10GbE;
  • “Slot 1” is the Internet Port
  • “Slot 2” is the LAN Port
  • If MSM765zl is installed, for instance, on slot “D”, the Slot 1 is “d1” CLI-wise and Slot 2 is “d2” CLI-wise.
  • Tagging (VLAN trunking Cisco) a VLAN on slot 1 on the CLI example: Switch(config)#   VLAN 5 tagged d1
  • Since ports are permanently connected, to simulate disconnecting a port disable the port.
  • Note: LAN Port should not be disabled on the MSM765zl Controller, since it carries Services Managent Agent (SMA) communications between the Controller and the switch, which delivers the clock to the controller. If you plan to only use the Internet port, then you can assign slot 2 port an unused VLAN ID untagged.
  • Configuring Controller’s IP address on the CLI if managing through the Internet Port: Switch(config)# ip interface wan     Switch(config)# ip address mode [static | dhcp]   Switch(config)# ip address < IP address/prefix length>

Disclamer: note that these are my own notes. HP is not responsable for any of the content here provided.

Advertisements

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s